They want to learn how to mig weld head as well as is possible, if the piece when you lay on a bench in front of you? Of course you can do, or you have not read this one.
Here's how. (These are only suggestions for MIG 1 / 8 "and thicker steel)
Do not fear the heat ... Kyss keep the short stick-swinging Observe the angle of the CCC ... clean, clean, clean
What I mean is, they can stand the heat? If you're a noob, you tend to think that to maintain the weldingroof and hangs like a bad case of hemorrhoids, you must turn off the speed and tension of the wire. FALSE. Need mig welding in the head just as hot as you, if welding in flat position in front of you. BUT, in order to make this work, you must ...
Kyss. Keep your stick-Short. Too long a stick-out (the amount of copper wire glued between the tip and the arc) will not allow smooth and flatten the arch beads.
During the same heatTogether they would flat position for welding, while keeping the stick-short (2.1 "or less) means that the weld bead helps his fist in Arc-Force and the Pearl does not sag and flatten.
Look at the angle of the dangle. The angle of the MIG gun, that is. Too much or too bad angle is 90 degrees is good and easy to pull is probably the best angle for penetration, but can be real ... sometimes you have to press the puddle. Just do not fool with that corner, if you push or pull themig gun.
Finally, good MIG welding techniques used in the world much good if you are welding on dirty, oily or rusty metal. Use a grinder, a burr carbide, a wire brush or whatever it takes to clean, clean, clean. The metal is not entirely clean, but easier to clean than dirty.
0 comments:
Post a Comment